Water to wire system with integral turbo turbine, generator and valve flow control
Brushless, special rare-earth permanent magnet alternator
Higher efficiency than ordinary alternator
Output voltage and frequency are controlled by the electronic load controller (with ballast)
Machine is compact, easy to install and requires little maintenance except lubricating the bearing every few months
Turbo turbine was designed for families in remote areas to produce power for their households easily and inexpensively
Units have been incredibly successful and today thousands are installed throughout the world
Turbines need very little water flow to run efficiently and produce significant power out
Standard configuration uses one nozzle
Water is collected upstream from the turbine and channeled in a pipe down to the turbine location
At the turbine, the water passes through a nozzle, where it accelerates, strike the turbine runner and turns a AC single-phase brushless permanent magnet alternator
Electric load controller is built on the alternator which stabilizes the voltage to 110V or 220V to protect electrical appliances during use
Installation is very simple and explained in the manual
Once installed there are no running costs and maintenance costs are very low
